Vinyl Roll Holder for DC4sx Issues

This group is for Summa Printers & Plotters. Questions and issues, advice on all things Summa.
Post Reply
Posts: 1
Joined: Tue Oct 06, 2020 3:29 pm

Vinyl Roll Holder for DC4sx Issues

Post by aft9176 » Tue Oct 06, 2020 3:46 pm

I've got a DC4sx, and recently 1 of the 2 holders you put on the ends has become a problem. The tightening mechanism is stuck, so it is impossible to loosen or tighten it anymore (by stuck I mean the bolt on the other side twists/plastic is cracked and no longer tight fitting). This makes the holder slowly twist out of the vinyl roll while it rotates during printing. I'm going to call and see if these are buyable, but for the meantime, wondering if anyone has had this happen or has any temporary solutions so I can keep printing?

20201006_153612.jpg (312.49 KiB) Viewed 102 times

Post Reply