Vision Print

Anything goes, sign related or otherwise. Other
manufacturers discussion welcome.

Post Reply
Ruddbow

Vision Print

Post by Ruddbow » Mon May 14, 2007 10:27 am

I received an inquiry on printing a one way rear window print. (Vision Print) I would like to try this. What have some of you veterans come across when doing these? I have the latest custom dot pattern from Summa for best results. Appreciate any advice.

zlmark
Posts: 373
Joined: Tue May 16, 2006 12:21 pm
Location: Frisco, Colorado
Contact:

Post by zlmark » Mon May 14, 2007 11:38 am

Signlab has the VisionPrint softward in their 7.1 Print/Cut,
other than that I'm not sure how you will do it with Summa
software.

Mark

Muts
Site Admin
Posts: 842
Joined: Thu Jan 26, 2006 11:40 pm
Location: New Jersey
Contact:

Post by Muts » Mon May 14, 2007 12:41 pm

Check usdot specs...for usdot patterns that are ok for automotive use.. if regulated in your state... I can't remember what I used of the top of my head...other then that it works well

Set your dot overlap to "half" or you get some visible print pass lines - more then usual :)

Post Reply