
Every time I seem to make some progress the further away it seems I am getting.
Here was my latest test, I played around with the screen freq. , adjusted the ribbon braking as mentioned in the forum, density within a 2500 range, and although these are not as vivid as the ones I originally had, the ribbon folds are still there. And now the banding is the most prominent I have seen.
If anyone has suffered through these same trials and tribulations please feel free to chime in.
It's a DC3+, here is the test pic

and the close up

I was thinking I could go into summa printer control and lower the density on the ribbon causing the issue, but I am not even sure which it is.
Thanks for chiming in.
Jeremy