Page 1 of 1

A few jobs from the first week with the DC4SX

Posted: Mon Mar 16, 2009 8:11 pm
by Ursta Graphics
Here are a couple of jobs from my first week with the machine. I'm still learning but so far so good!

Image

This was the first thing I ran. CMY 35 ellipse I believe.

Image

It's awesome to finally be able to produce my shop mascot in house :) (Fridge)

Image

Done for a local video store. 35 ellipse. CMYK

Image

This is the smallest thing I have done so far. Couldn't quite get the settings right but it came out ok in the end. I think this was done at 41 double dot. (Any suggestions settings for small stuff will be kindly appreciated.)

I have quite a bit to learn and a few huge jobs coming up... so I'm sureI'll be bugging everyone soon ;)

Re: A few jobs from the first week with the DC4SX

Posted: Tue Mar 17, 2009 5:03 pm
by TogaTony
Excellent work!
Did you top-coat, use a clear vinyl overlaminate or Summa ScratchGuard?
What vinyl did you use?

Tony

Re: A few jobs from the first week with the DC4SX

Posted: Sun Mar 22, 2009 12:35 pm
by Muts
Very nice! - look forward to seeing more.

Re: A few jobs from the first week with the DC4SX

Posted: Thu Mar 26, 2009 12:08 pm
by Ursta Graphics
I have yet to laminate anything as I do not have the equipment for it yet. I'm hoping this isn't a bad thing. Sold the customers on a 3-5 yr warranty uncoated? Still kinda learning the ropes.

Re: A few jobs from the first week with the DC4SX

Posted: Fri Mar 27, 2009 7:47 am
by Muts
who needs a machine :)

Laminating on a Dime

Re: A few jobs from the first week with the DC4SX

Posted: Sun Aug 09, 2009 5:50 pm
by mjm67
excellent work, what were your settings for the 1st print .. ie lpi / screen
and what program did you set it up in.

thanks matt