no this is not Homer Simpson:
and the finished results:
Elz's Partial Wrap
Elz's Partial Wrap
I had the pleasure of helping a good friend of mine this past Tuesday. He gets all the props for the design work and a gazillion passes on the DC3 head. The two sides were 140"+ long. Material used was Mactac Bfree 5529, with a cheap Lamex 4m (Mactac recommends thinner). For a couple of novices we had a lot of fun. Like this forum I learned alot, both about my DC, lamination and that most times I sell this machine short in expectations. So here are a few pics for your enjoyment.
no this is not Homer Simpson:
and the finished results:
no this is not Homer Simpson:
and the finished results:
Summa S75, DC3+ Hobby signmaker.