Elz's Partial Wrap

Show off your stuff. Describe techniques & materials used to create and apply. Time involved. Final thoughts on completed work.
Post Reply
Ruddbow
Posts: 102
Joined: Thu Aug 09, 2007 11:52 am

Elz's Partial Wrap

Post by Ruddbow » Sat Mar 29, 2008 9:41 am

I had the pleasure of helping a good friend of mine this past Tuesday. He gets all the props for the design work and a gazillion passes on the DC3 head. The two sides were 140"+ long. Material used was Mactac Bfree 5529, with a cheap Lamex 4m (Mactac recommends thinner). For a couple of novices we had a lot of fun. Like this forum I learned alot, both about my DC, lamination and that most times I sell this machine short in expectations. So here are a few pics for your enjoyment.
Image
Image
Image
no this is not Homer Simpson:
Image
and the finished results:
Image
Summa S75, DC3+ Hobby signmaker.

Muts
Site Admin
Posts: 841
Joined: Thu Jan 26, 2006 11:40 pm
Location: New Jersey
Contact:

Post by Muts » Mon Mar 31, 2008 3:31 pm

shhhhhhhhhhhhwwwwwweeeeeeeeeeeeeeeeeet!

Red has a nice pop to it. What was it designed in? Screens?

Post Reply