little blank spots when printing

[beachnsled]

wild! Floor wax!

I think I will invest in a good set of these paint markers for sure. I find that Sharpie brand is too thin to cover even the smalles of spots - plus, the colors are barely passable. sled (I am beach - he is sled! lol) was commissioned to paint a mural for a little girl's room - that's what he used & even after nearly 5 yrs, the mural looks like it was painted yesterday. Weird how I didn't even think to use them for the summa prints.

I wonder how often folks use this site - while visiting Summa in Mass, we were talking about how this is really the only place on-line to find any info & current users of Summa printers. The guys mentioned how everyone on here is VERY well versed in all things related!

[RA-Graphics]

I'm having this same issue. Yes, Density problem. Can occur even if you are using the same material over and over again.

Always seems to happen with Black Ribbon than any other color.

I've also taped Half Strip of Bounce Sheets on each end (back of the machine) so that it touches the corner of material to reduce static. Building where the machine is has lots of windows and I can't stick the machine in the center of the floor. This has drastically, reduced the white dust spots.

[TogaTony]

Where exactly are you placing the 'Bounce' fabric softener sheets?
Can you send a photo?
THX!