First Jobs ripped from Signlab 9

[Ursta Graphics]

After working out some bugs in signlabs vpm I finally got these to print. Prints were done 50lpi 300 dpi 50 tridot.

[zlmark]

Real nice looking graphics. How did you do the prismatic on the barber sign?

Mark

[Ruddbow]

Outstanding!

[Muts]

One thing resin definitely has over inkjets.... RED

Nice job

[KyJoe340]

Could you be more specific about the bugs you worked out in Signlab 9's VPM. I'm also using 9 and whenever I try something other than default (small eucledean ellipse 600dpi 100lpi) everything is pixelated to a point it's not acceptable.

[Ursta Graphics]

Try running it at 300dpi 50Lpi 55 round or 55 tri dot.

[JR's]

Sweet, Sweet, Sweet!

[zlmark]

KyJoe,
What he is saying is you get into the printer device setup/haltone overrides and change
the settings from there. I was wondering Ursta, the dot 'angle', that really doesn't change
I think. What do you say?

Mark